Bơm mỡ, bơm dầu bôi trơn tự động LUBE AMZ-III
Model indication method
Specifications
| Pump |
Discharge Volume |
90mℓ/min（50Hz）
110mℓ/min（60Hz） |
| Discharge Pressure |
1.5MPa（safety valve set pressure） |
| Motor |
Voltage / Current |
AC100Vφ1/1.5A |
| AC200Vφ1/0.8A（50Hz） |
| AC100Vφ1/1.3A |
| AC200Vφ1/0.7A（60Hz） |
| AC230Vφ1/0.7A（50Hz） |
| AC230Vφ1/0.6A（60Hz） |
| Output |
19W（50Hz） 18W（60Hz）
Shading motor |
| Emergency Detection |
Oil Level Switch |
Oil level pressure |
Contact type A Contact (NO)ON at low level
Contact capacity 0.5A、AC DC200V/30Wsmaller |
| Prerssure switch |
Contact type A Contact (NO)
Working Pressure：1.3MPa ON
Return Pressure：0.9MPa OFF |
| Contact capacityAC DC250V/2A |
| Operation Rating |
The maximum discharge time is less than 1 minute, and the minimum rest time is 3 minutes or more |
| Operating viscosity range |
50〜1300mm²/s（50Hz） |
| Reservoir Capacity |
1.8ℓ、3ℓ（plastic）3ℓ、4ℓ、8ℓ（sheet metal） |
| Weight |
1.8ℓReservoir：2.7kg、3ℓReservoir：3.6kg |
| External fuse |
100V/2.0A 200V/1.0A |
| Model |
Part Number |
| AMZ-III -1 |
285017 |
| AMZ-III -1-3 |
285024 |
| AMZ-III -2 |
285016 |
| AMZ-III -2-3 |
285023 |
Low viscosity Specifications
| |
Model |
Part Number |
Voltage |
Reservoir |
Operating viscosity range |
| 1 |
AMZ-III -100SL-18LP |
285224 |
100V |
1.8ℓ |
22 ~ 800mm2/S |
| 2 |
AMZ-III -100SL-18LP |
285426 |
200V |
1.8ℓ |
22 ~ 800mm2/S |
| 3 |
AMZ-III -23 |
285433 |
230V |
1.8ℓ |
22 ~ 800mm2/S |
Directions for use
● This Pump unit requires a separate control circuit.
● Do not remove the oil strainer. It may cause contamination.
● For the suction filter, target pump or clean it once a year. Please see the adaptation table.
● Since the viscosity changes depending on the oil temperature in summer and winter, be careful to use it within the Operating viscosity range. Please see the viscosity table.
● Do not use special additive oil, water-soluble oil or solvent.
● Regularly inspect the oil in use for contamination, etc. If any are found, immediately flush the Reservoir and make a new oil and Target Pump.
● Please be careful about mistakes such as Voltage.
● Do not overtighten the outlet fitting. Please refer to the tightening torque chart.
● Low viscosity Specifications are also available, so please contact our Global Center.