- The passage opens a screw when I loosen it to を left mawashi. When I turn it and regulate by little so that the touch of the guideline of the gauge becomes the most oppression in a startup in around one second, generally, as for the adjustment, the best suppressant effect is provided for the pulsation pressure.
- The fluid flow is usually cut off because it is tightened は center screw. Please confirm it by a driver for sense. A screw becomes easy to turn を six angles of stuffing nuts when I loosen を to some extent.
- I put a seal of [please do not touch it for adjustment finished] for を adjustment finished and ship it, but, as for the product which I inserted ダンプナー in between a diaphragm device and gauges, the effect that you should fine-tune in the optimum depending on pulsation width for a pulsation cycle of use ahead may be provided a leading screw beforehand.
- Finally a hexagon nut, please tighten を.
- You gradually tighten it so that pulsatile width becomes small as much as possible from the position that pulsation pressure adjustment lowered at the time of main constituent a little, and please adjust it. The degree to tighten a screw differs by a property of the pitch of a fluid and the pressure or the pulsation pressure, but is within around 0.5-1.5 rounds from the position that I closed. Because you are damaged when it goes back up too much, please be careful.