Thiết bị kiểm tra lắp đặt điện đa chức năng Sonel MPI-530

Thiết bị kiểm tra lắp đặt điện đa chức năng Sonel MPI-530

Thiết bị kiểm tra lắp đặt điện đa chức năng Sonel MPI-530

 Measurement of short circuit loop impedance:

• impedance measurement with resolution 0,001 Ω and 23 A current (44 A phase-to-phase) - short-circuit resistor R_ZW = 10 Ω,
• measurement range: 95...440 V, frequency 45...65 Hz,
• measurement of short circuit loop impedance with resolution 0,01 Ω, in protected systems without tripping the RCD’s with I_Δn ≥ 30 mA,
• automatic calculation of short-circuit current, differentiating between phase-to-phase and phase-to-neutral voltage,
• measurements using UNI-Schuko plug with measurement triggering  button (also when L and N leads are exchangeable) or 1,2 m, 5 m, 10 m, 20 m test leads, with optional use of  3-phase socket adapters (AGT),
• selection of installation protections and automatic evaluation of measurements results.

Tests of residual current devices (RCD), types AC, A, F, B and B+:

• measurement of general, short-time delay and selective RCD’s with rated residual current of 10, 30, 100, 300, 500 And 1000 mA,
• automatic measurement of all RCD parameters (when the START button is pressed, the meter performs the whole measurement cycle, including the.

L-PE short circuit loop impedance measurement with 15 mA current),

• user selected waveform of forced leakage current: sinusoidal (start from increasing or decreasing edge), unidirectional pulsating (positive or negative), unidirectional pulsating with DC bias (positive and negative), direct (positive and negative),
• measurement of tripping current I_A using the ramp current,
• measurement of tripping time t_A at  ½I_Δn, 1I_Δn, 2I_Δn and 5I_Δn ,
• measurement of touch voltage UB and protective conductor resistance R_E without the RCD tripping,
• detection that L and N conductors are switched in the socket; will not affect the measurement,
• measurement of tripping current  I_A and actual tripping time t_AI at single activation of RCD,
• measurement for 95...270 V voltage.

Insulation resistance measurements:

• test voltage values: 50 V, 100 V,  250 V,  500 V  and 1000 V,
• insulation resistance measurements up to 10 GΩ,
• in-socket measurements using the UNI-Schuko adapter,
• meter is protected against voltage on the tested object and voltage appearing during the measurement,
• auto-discharge of the object after the measurement,
• automatic measurement of all resistance combinations in three-, four- and five core leads using the additional AutoISO-1000C adapter,
• acoustic signalling of five-second periods to enable determining the time profile during the insulation resistance measurements.