| Differential pressure |
Resolving power
Precision guaranteed range
Excess pressure on sensors
Sensor precision |
0.1 Pa
±1000 Pa
5 MPa
±2.5% of rdg ±1Pa, however 50Pa or below is ±2Pa |
| Display units |
Test Pressure: |
kPa、MPa
(Non-SI units for overseas: PSI, kg/cm2, bar, mbar, mmHg, cmHg, inHg, etc.) |
| Leak volume |
mL/min, L/min, mL/s, Pa/s, Pa/min, Pa, kPa, Pa・m3/s, E-3 Pa・m3/s , etc.(Non-SI units for overseas: mmH20, mmHg, inH20, etc.) |
| Displayed leak volume |
4 digits, sample rate: 10/second |
| Number of Channels |
32ch（0～31） |
| Timer setting range |
999.9 seconds (resolving power: 0.1 second) |
| Power Source |
AC100～240V±10%, 50/60Hz, 70VAmax |
| Test pressure source |
Uses clean air.
The original pressure must be sufficiently higher than the test pressure. |
| Pilot pressure source |
Applies 400 to 700kPa of clean air. |
| CPU |
SH-2A 144MHz, DRAM 8MB |
| Pipe connection diameter |
Rc1/4 (test pressure supply, workpiece piping, master piping)
6mm one-touch joint (pilot air supply) |
| Ambient temperature |
Operating temperature 5 to 45°C Storage temperature: -20 to 60°C |
| Humidity |
80 %RH or less No dew condensation |
| Mass |
Approx. 10kg |
Serial communications RS232C-based
(D-sub9-pin) |
I/F fixed length output |
Leak data and set values are outputted simultaneously |
ID/F fixed length output
Standard settings |
Leak data and set values are outputted simultaneously |
| T/F fixed length output |
Only leak data outputted |
| USB Port |
Saving data |
Saves decisions, leak values, test pressure, WK#, CH#, and time on inserted memory. |
| Set value output |
Set values of all settings screens |
| Standard accessories |
Power cord |
For use in Japan: Rating: AC125V/7A, length: 3m
For export: Rating: AC240V/10A, length: 2m (CE conformant product)
|
| Control I/O connector, cap for RS-232C, USB cover, test report, traceability documents, user manual |